Tools & Home Improvement From Taytools on Amazon

This adjustable in-line bench dog clamp allows you to secure work flat to your workbench anywhere there are 3/4” dog holes. The post is just shy of 3/4”, so will slip in and out of any 3/4 inch dog hole. Used in conjunction with a plane stop or bench dogs, you can secure virtually any size or shape workpiece anywhere on your bench.

You can clamp parts equally well on the top or edge of a workbench. The low-profile design sits just 11/16 of an inch above the surface of your bench, so will not interfere when planning or sanding 3/4 inch thick material. The post is 2-5/8” long overall and can extend a full 2 inch into a benchtop.

Specially designed to apply even and pressure when installing plastic laminate and wood veneers laminates

12” long bent steel plastic coated handle for optimal leverage

Outside diameter: 2-7/8"

Inside diameter: 2-1/2"

Cutting Diameter: 5mm

Cutting Height: 20mm

This quick-adjust vertical surface hold down clamp allows you to secure work tightly to your workbench anywhere you can drill 3/4 inch dog holes. The 1-1/2 inch long post is just shy of 3/4 inch, so will slip in and out of any 3/4 inch dog hole. The post has machined serrations along its length so when the handle is turned and pressure applied, the post wedges tightly in a dog hole and will not slip. This clamp will work in tops as thin as 3/4 inch thick.

The cast zinc base is 1-1/2 inches in diameter and 1-1/2 inches tall. The base and post are black coated to resist corrosion.

NOT designed to fit any brand of T track

10 each sliding T Tee nuts

Has built in wall mounting bracket to allow secure anchoring to prevent sloppy opening/closing.

Will fit 4" flexible dust collection hose or tapered dust fittings

25 pack

These slide-in T-nuts with a centered thread hole are a cost-effective fastening option for T-Track and other aluminum extrusions.

Hex shaft accepted: 1/4 inch (6.35mm)

Depth of hole: .820 inch

Set of 2 each 2-1/2"" aluminum blast gates

Designed to fit 2-1/2" ID diameter hose or ducts