Automotive From Rockville on Amazon

Fully Marinized Against Salt & Fresh Water Conditions. Completely Waterproof and rustproof. Molded ABS plastic basket. Rubber Surround.

1 Voice Coil. 5.4 oz Y30 magnet. Pre-installed mounting screws included. Perfect for both marine, outdoor, and car use. Impedance: 4 Ohms.

Frequency Response: 60Hz - 18KHz. Sensitivity: 90 dB. Total Diameter: 7.32 inches. Cutout Diameter: 5.31 inches. Total Height: 1.57 inches. Mounting Depth: 0.925 inches

Some Compatible Subwoofers: CLARION: PFW1051, SFW1051, PIONEER: TS-SW1041D, TS-SW2541D, TS-SW251, Ts-SW1241D, TS-SW3041D, TS-SW301, JL AUDIO: 12TW53, 13TW53. Enclosure Measurements: Type of Enclosure: Sealed Shallow. Enclosure Sub Size: Single 10". Dimensions in Inches: 18.25" x 5.5" x 14.25"

Top and Bottom Depth: 5.5". Mounting Depth: up to 4.5" (enough depth for any shallow sub on the market). Gross Volume Per Sub (Measurement for the outer dimensions of the box): 0.83 Cubic Feet

Net Volume Per Sub (Measurement for the outer dimensions of the box less the thickness of the wood): 0.62 Cubic Feet

13.6 mm Peak-to-Peak X-Max. 40 oz. Magnet. Slim Vented MDF Enclosure Design. Impedance: 4-ohms. Frequency response: 30Hz-500Hz. SPL @ 1w/1m: 89dB. Dimensions: 29.52" Length x 15" Height 4.37" Top Depth x 6.65" Bottom depth. Unit Weight: 40.12 Lbs

Amp Features: Built-in 500 Watts RMS / 2000 Watt Mono Block Amplifier. 2 Ohm stable amplifier. Class D amplifier. Extruded aluminum heatsink stays cool even at high volumes. 200mV – 5V Variable Input Level. 12dB Low Pass Crossover Frequency 50Hz-200Hz. Low Level RCA Inputs. Remote level attenuation: 0 to -32.2 dB. 3.7 second turn on delay. High Level Speaker Level Input with Auto Start Music Sense. RJ11 Jack for Dash Mounted Bass Remote

Rockville RWK81 8 Gauge 2 Channel Car Amplifier Wiring Installation Kit. (1) 17’ High Grade Twisted Pair of 100% Copper RCA Cable. 17’ 8 Gauge Translucent Blue Super Flex Power Cables. 17’ 18 Gauge Blue Remote Cable. 17’ 16 Gauge Clear Speaker Wire. 3’ 8 Gauge Super Flex Ground Wire. Gold Plated AGU Heat Resistant Fuse Holder. 60 Amp AGU Gold Plated Fuse. 7’ Split Tube Loom. Accessories Included: Wire Ties, Ring Terminals, Butt Connectors, Spades, and Grommets. Soft abrasion proof insulating jacket allows for 100% improved flexibility. PVC outer jacket can with-stand an extreme temperature range of -40 to 220 degrees F

Amp Features: Built-in 500 Watts RMS / 2000 Watt Mono Block Amplifier, 2 Ohm stable amplifier, Class D amplifier, Extruded aluminum heatsink stays cool even at high volumes, 200mV – 5V Variable Input Level

12dB Low Pass Crossover Frequency 50Hz-200Hz, Low Level RCA Inputs, Remote level attenuation: 0 to -32.2 dB, 3.7 second turn on delay, High Level Speaker Level Input with Auto Start Music Sense, RJ11 Jack for Dash Mounted Bass Remote

Blue LED on each Equalizer Slide Control

RCA stereo input: DVD/Tape/Tuner/Aux-MP3 with Front Panel Selector Switch

RCA Stereo Record Output. Front Panel 3.5mm iPod/MP3 Player Input Jack

Dual VU Meters Level Monitor. Individual LED Indicators

Outputs-RCA (REC). Multi Color LED Display

Low/High Display Function. Frequency Response: 20-20,000 Hz

Signal to Noise Ratio: 80dB

Removable Rack Mount Brackets

Satin Nickel speaker wire push terminals. Enclosure air space is 1.52 Cu Ft per sub. Vent dimensions (inches): 2.25" x 7" x 8.5". Tuning frequency of enclosure: 35 Hz. 2" 4-Layer Black Aluminum Voice Coils Wound with OFC (100% Copper) Wire.

Features of Amplifier: Rockville dB11 1400w/700w RMS 2-Ohm Class-D Mono Car Amplifier and Bass Remote.

CEA Compliant Power Ratings (Rated at less than 1% distortion) (Use these CEA ratings when matching and comparing with other CEA compliant brands such as Kicker, Rockford Fosgate, etc.).

- 2 Ohm: 350 Watts x 1 Channel <1% THD+N. - 4 Ohm: 220 Watts x 1 Channel <1% THD+N. Peak Power Rating: (The amount of power the amplifier can produce for a split second at the loudest part of a song).

Features of wire kit:: Rockville RWK81 8 Gauge 2 Channel Car Amplifier Wiring Installation Kit. (1) 17 High Grade Twisted Pair of 100% Copper RCA Cable. 17 8 Gauge Translucent Blue SuperFlex Power Cables.

17 18 Gauge Blue Remote Cable. 17 16 Gauge Clear Speaker Wire. 3 8 Gauge SuperFlex Ground Wire. Gold Plated AGU Heat Resistant Fuse Holder. 60 Amp AGU Gold Plated Fuse.

7 Split Tube Loom. Accessories Included: Wire Ties, Ring Terminals, Butt Connectors, Spades, and Grommets. Soft abrasion proof insulating jacket allows for 100% improved flexibility.

PVC outer jacket can with-stand an extreme temperature range of -40 to 220 degrees F

IPX6 Water Resistance Rated. Marine-grade components are protected from the outdoor elements. Adjustable Aluminum Mounting Bracket is Strong and Sturdy. Bracket Swivels 360 Degrees (Fixed swivel).

Bracket supports any rollbar from 1.5" to 2" inches thick. 6.5" Woofers with 11 oz Magnets and Oversized 1.25” Kapton Voice Coils. 1" PEI Dome Tweeters with Neo magnets. RGB lighting remote can control mode, color, brightness.

Built-In Two-Way Crossover Network. Fully Marinized Against Salt & Fresh Water Conditions. Completely Resistant to Water, Rust, and UV Rays. Terminals Are Sealed with Rubber Gaskets. Polypropylene Mica Injected Cone with Butyl Rubber Surround. RCA output

Frequency Response: 122Hz – 20 KHz. Sensitivity: 85dB @1w/1m. High quality magnet: 3. 5 Oz Y30 Ferrite magnet. 1” inch ASV voice coil. IP56 waterproof rating.

Anti-UV molded ABS plastic basket & grill. Pre-installed mounting screws included. Perfect for marine, outdoor, and car use. 1” inch Tweeter: (Mylar Diaphragm with NdFeB magnet). Injection Molded Polypropylene Dust Cap. SPL: 85dB 2dB (at 1M / 1W).

Resonant Frequency (F0) 122Hz + or – 20% at 1V. 3MM plate and 3 MM T-yoke. Total Diameter: 5. 12”. Cutout Diameter in Inches for Mounting: 3. 66”. Total Height: 2. 36”.

Shallow Mount Subwoofer. Impedance: SVC 2 Ohm. Cutout Diameter: 7 Inches. Mounting Depth: 2.5 Inches. Frequency Response: 39 Hz to 500 Hz. Sensitivity: 90dB @ 1w/1m. Voice Coil: 1.5” High Power Voice Coil. Magnet Structure: 64 oz. Washer/Yoke Plates: 6mm Machined Steel. X-Max: 8.4mm Peak-to-Peak

The Rockville W8T4-S2 subwoofers feature a 2-Ohm single voice coil. These subwoofers are engineered to deliver serious low frequency response where space is limited. Whether installed behind the seat in a compact car, pick-up truck or in a motorcycle's saddlebags, make no mistake Rockville T4 subs will rock you!

The Rockville W8T4-S2 is CEA-2031 compliant and rated with an amazing 1000 watts peak and 250 watts RMS. That means you are getting 100% accurate RMS power ratings. These days lots of brands have competitions over how many thousands of watts they can write on the box of their items.

Rockville W8T4-S2 8" Subwoofers feature the thinnest mounting depths available making them the best shallow-mount driver's suitable for the most intricate bass installations. Deep bass that's made to fit where standard-sized subwoofers can’t. What else can you ask for? <br> The Rockville W8T4-S2 subwoofers feature a 2-Ohm single voice coil. These subwoofers are engineered to deliver serious low frequency response where space is limited. Whether installed behind the seat in a compact car, pick-up truck or in a motorcycle's saddlebags, make no mistake Rockville T4 subs will rock you!</p> <p>Features:</p> <p>Rockville W8T4-S2 8” 1000 Watt 2-Ohm Shallow Mount Car Subwoofer<br> Power Handling: 1000 Watts Peak Power / 500 Watts Program / 250 Watts RMS (CEA Rating)<br> Ultra Stiff Paper Composite Cone<br> 3D Molded High Gloss Acrylic Dust Cap<br> Ultra Slim, Expanded and Rolled Steel Basket<br> High Density Laminated Butyl Rubber Surround<br> High Power Strontium Magnet with Ultra Saturated, High BL Motor Gap<br> Vented Core Magnet Motor Structure<br> High Temperature Aluminum Voice Coil Former<br> Lightweight Compact Design Ideal for Any Installation<br> Magnet Protection Rubber Band<br> Dual Nickel Plated Spring Loaded Push Terminals<br> Shallow Mount Subwoofer<br> Impedance: SVC 2 Ohm<br> Cutout Diameter: 7 Inches<br> Mounting Depth: 2.5 Inches<br> Frequency Response: 39 Hz to 500 Hz<br> Sensitivity: 90dB @ 1w/1m<br> Voice Coil: 1.5” High Power Voice Coil<br> Magnet Structure: 64 oz<br> Washer/Yoke Plates: 6mm Machined Steel<br> X-Max: 8.4mm Peak-to-Peak<br> Enclosure Recommendations:<br> Sealed: 0.35 cu. Ft - 0.85 Cu. Ft. <br> Vented Tuned at 35Hz: Not Recommended <br> Vented Tuned at 45Hz: 1.00 cu. Ft. - 2.00 Cu. Ft.