Tools & Home Improvement From FainWan on Amazon

Pins of single color led strip:2-pins

Please choose connector according to led strip specification

For led strip 3528 5050 8mm / 10mm width PCB ribbon

Two blades, one for stripping and one for cutting.

Adjustable 2 blade construction and stripping distance: 4mm, 6mm, 8mm or 12mm

Smooth plastic grip provide extra comfort and hard plastic construction for durability.

Designed to Compatible with specific Electro-lux manufactured refrigerator models including Crosley, Frigidaire, Gibson, and Kelvinator.

Strong Conductivity Are made of high quality metal material, has good electrical conductivity

Sturdy & Heavy Duty This crocodile clip is rust-proof, corrosion-resistant, oxidation-resistant, compact and durable

Widely Used The test conductor set connects a compatible electrical tester to the equipment for testing.Suitable for measuring various currents, voltages and resistances

Characteristic: Could be used with any Ar-duino or microcontroller

Feature: 3.3V regulator and level shifting

Feature: Could be used with any 2, 3 or 4 wire PT100 RTD

This ESP-01/01S Relay based on ESP-01/01S WIFI module. It is designed for smart home, internet and other DIY projects. With this smart relay, it is easy to DIY your smart switch to control any device by your phone anywhere.

Transmission distance: the maximum transmission distance of 400m (open environment, mobile phone equipped with WIFI module)

The intelligent relay module based on ESP-01S WIFI module design, can be used for DIY their own smart switch, you can remotely control through the mobile phone APP

3. the maximum power of 120W (12V induction heating). Push the ignition coil 12V when the primary 5 + 5 turns 30W or so.

4. the input voltage DC 5V ~ 12V (5V voltage exceeds 12V or lower than the seller is not guaranteed to work properly the input voltage is not within this range a problem the seller is not liable!)

5.Make sure that all components soldered correctly the power line is not reversed negative then power!

On-board momentary push button to set the low voltage disconnect parameter and 3 digit red LED display the parameter easy to operation.When the battery voltage reach the setting values, the module will disconnect load automatically to aviod the battery from over discharging to prolong the battery lifetime. Reference formula: charging voltage = rated voltage x 1.2; charging current = rated current x 0.2

Reset:When the power is off, press and hold the two buttons at the same time, and then power on. At this time, the screen displays "888", indicating that the factory settings are restored.The factory-set protection value: 12V, difference value: 2V. Difference Value"is the value between the battery voltage to disconnect and the battery voltage to reconnect.

Display is accurate, the switch module is quickly to open and close when near minimum voltage; Settings is stored non-volatile, it can keep set when power off

Accuracy: Range from ±3% at best to over ±10% in less optimal conditions

Maximum Sensoring Distance: 2m

Working Voltage: 2.6V - 5.5V

Automatic detection of NPN and PNP transistors, n-channel and p-channel MOSFET, diode (including double diode), thyristor, transistor, resistor and capacitor and other components. Automatic test the pin of a component, and display on the LCD.

Can measure a single diode reverse capacitance. If the bipolar transistor connected to the base and collector or emitter of a pin. It can measure the collector or emitter junction reverse capacitance .

Automatically detect NPN, PNP bipolar transistors , N -channel and P -channel MOS FET, JFET , diodes , two diodes, thyristors small power unidirectional and bidirectional thyristor. Automatic identification components pin arrangement .