Automotive From Chimera on Amazon

Chimera Grom 125 Gasket for the Right side of the crank case.

While sitting on the bike it the one on your right side.

Chimera Engineering CNC clutch plates are machined from T-6061 aluminum.

Highly recommended for those who are planning to run stiffer clutch springs, the increased spring rate will put more stress on the clutch plate tabs.

When you remove the factory air box, the left and right panels will flap around and move because there isn't anything securing the the halves. Chimera Grom 125 / MSX 125 fairing rod will brace the left and right body panels and prevent them from moving while riding.

Made from T6061 aluminum with a nice anodized black finish.

Looking to lower the rear of your GROM a bit to go with the lower front end? Want to lower it without needing to install a stretch? Here you go! Chimera 2.5" rear lowering link kit requires no drilling, and can be installed with the bike on the ground when it's properly supported (because you have to remove the rear shock). You do not need to remove the chain/wheel/etc to install if you are not using a stretch.

*PLEASE READ: If your axle adjustment is currently in the middle of the adjustment range, or further back, then this kit will fit. If your sprocket/chain combo is such that your axle is in the forward-range of the adjustment area, the tire may be too close to the shock mount to fit without a stretch installed! Verify your axle adjustment range and that you have at least ¾” distance between the leading edge of the tire and the rear part of the swingarm cross-bar that the shock mount is welded to.

Compatible with vehicle type: All-Terrain-Vehicles

Fit type: 2014+ Grom 125

- Improve performance

- Retains Stock IAT Sensor and Crankcase Breather Hose - Very Important

Chimera Engineering CNC clutch pressure plate is made from T-6061 aluminum!

Direct replacement for the weak cast aluminum OEM unit that generally breaks when stiffer clutch springs are installed.

Chimera Premium Gasket contains silicone impregnated on both sides of the gasket.

While sitting on the bike it is the one on your left side.

BLACK CHIMERA AIR INTAKE - Improve performance

- Retains Stock Crankcase Breather Hose - Very Important

Chimera Thumb Screw Idle Adjuster with Spring for Honda Grom 125 or Kawasaki Z125.

Idle adjustment made easier for all those Honda Grom or Kawasaki Z 125 stunt riders or those who want to dial in their big bore engines. You now can adjust your idle without any tools. Simply replace screw and nut from your throttlebody and install thumb screw and spring.